PREPARATION PREPARATION OF ESPRESSO ESPRESSO PODS WITH
Thanks to the special pressurized portafilter mechanic can make a great creamy coffee in bars.
Insert the portafilter into the boiler (7) and turn it from left to right until it locks, so you can preheat. Leave the handle of the filter holder.
An automatic system now reports the handle holder slightly to the left. This movement ensures perfect functioning of the filter over time.
Ascertain that the amount of water in the tank is sufficient.
Press the main switch (1).
Wait for the light in the coffee switch (3) goes off.
The device is now at the right temperature for the water supply.
Remove the filter holder from the boiler group (7) and insert the filter great for coffee in the portafilter.
Fill the filter with one or two scoops of ground coffee depending on the number of coffee to prepare.
approx 1 scoop = 1 coffee
ca 2 = 2 scoops coffee
The quantity and the pressing of the coffee powder and sul'aroma directly affect the quality of the coffee.
Lightly press the coffee with the spoon and wipe the top edge of the holder of any residual coffee.
Insert the portafilter into the boiler (7) as described above.
Place one or two pre-warmed cups under the filter holder.
Press the coffee switch (3) to the desired amount of coffee, turn off the coffee switch (3).
When the operations remove the filter holder, empty out the filter holder and rinse with running water.
PREPARATION WITH ESPRESSO PODS
The pressurized portafilter mechanic can also be used for the preparation of espresso with the system for wafers, as follows:
Remove the filter from the filter holder.
Insert the gasket into the pod holder with the side containing the 4 tabs upward
Place the small filter into the filter holder for pods. To get a first good quality coffee is recommended that the filter, the filter and the cup are preheated.
Insert the portafilter into the boiler (7) and turn it from left to right until it locks, so you can preheat. Let go of the handle holder.
An automatic system now reports the handle holder slightly to the left. This movement ensures perfect functioning of the filter over time.
Ascertain that the amount of water in the tank is sufficient. Press the main switch (1).
Wait for the light in the coffee switch (3) goes off.
The device is now at the right temperature for espresso with coffee capsules.
Remove the filter holder from the boiler group (7) by turning to the left.
Insert the filter into the wafer, the wafer handling with care to avoid damaging it.
Insert the filter holder with filter and pod into the boiler unit (7) and turn it clockwise until it locks.
Place a cup under the filter holder and press the coffee switch.
To the amount of coffee you want to turn off the coffee switch (3).
After preparing the coffee, remove the filter holder by turning it clockwise, throw the pod already extracted and rinse the filter under running water.
